The SQUARE SunPipe system is ideally suited to an application where there is a normal flat ceiling to the room, as opposed to a typical loft conversion, where a normal rooflight can be used.  The highly reflective aluminium SunPipe tube reflects and intensifies sunlight and normal daylight into the room below.  The light is spread evenly by the patented recessed SunPipe diffuser, without glare and eliminating heat transfer.

The Monodraught Square SunPipe has been specifically developed to provide an unobtrusive termination for any roof finish. The Square SunPipe is in addition to SunPipe's range of Diamond, hemispherical and Conservation SunPipes and is initially produced as standard in a 600 x 600mm nominal format which includes an adaptor to fit to any of the following circular SunPipe systems:

9" (230mm) Diameter,

12" (300mm) Diameter,

18" (450mm) Diameter,

21" (530mm) Diameter.

Designed to the highest standards

The Square SunPipe is constructed to the highest specification with 2mm thick CR4 Steel, zinc plated to 25 microns and polyester powder coated to 75 microns to a range of colours.